Sign up Calendar Latest Topics Donate
 
 
 


Reply
  Author   Comment  
hriveraq

Member
Registered:
Posts: 13
Reply with quote  #1 

Goodnight guys:

What type of sensor should I use for a pulp stirrer shaft, requires stationary placement on bearings CMSS 2200 vs CMSS 2100

 
Attached Files
pdf Untitled.pdf (235.01 KB, 16 views)

fburgos

Sr. Member
Registered:
Posts: 670
Reply with quote  #2 
Don't know about pulp stirrer... But what's your shaft speed?
Vibe-Rater

Avatar / Picture

Sr. Member / Moderator / Supporter
Registered:
Posts: 1,397
Reply with quote  #3 
Just use a 100 mv / g. Normal cheap all will be  good I m not shoer what a stirrer is. Is it in a pulp mill anda pulper in which case 2 3 4 hundred rpm. Stay healtthy you'all. rgds from Australia sorry for all the spells Im in a super hurry.
Walt Strong

Sr. Member
Registered:
Posts: 889
Reply with quote  #4 
There isn't much difference in key specifications, so either one would be good choice. If you are using an integral cable for permanent installation, then the side mount model would be easier to install and remove for maintenance. It also cost more than the top mount accelerometer. 

Walt
Previous Topic | Next Topic
Print
Reply

Quick Navigation:

Easily create a Forum Website with Website Toolbox.